Installing Long Cables into Push-to-Connect Fittings and Tensioning Cables
21b
PTC Fitting Engagement
Release Tool
Turnbuckle Engagement
Notes: » An adjustable wrench can also be used on the flat sides of the PTC fitting. » Use the release tool on the turnbuckle wrench to release the cable from the PTC fitting if needed. PTC fittings are intended to be single use after the cable has been tensioned. Do NOT reuse PTC fittings after tensioning. » Before using the release tool, unthread the PTC fitting from the turnbuckle so that there is no tension on the cable. IMPORTANT NOTE: FOLLOW THESE STEPS AFTER ALL HORIZONTAL AND STAIR RAILING SECTIONS HAVE BEEN INSTALLED.
21b. Place a second wrench on the turnbuckle as shown so that it locks in place with the cutouts on the end of the turnbuckle.
21a
21a. U sing the turnbuckle wrench(es) provided (one per kit), place one wrench on the flat sides of the PTC fitting.
9
Have Questions? 1–800–BUY–TREX
NOTE: Construction methods are always improving. Please ensure you have the most up-to-date installation instructions by visiting: trex.com
XSSTC-0725
Made with FlippingBook. PDF to flipbook with ease