TREX SIGNATURE® X-SERIES™ STAIR CABLE RAIL Installation Instructions
Centering Cable Brace
Installing Long Cables into Push-to-Connect Fittings and Tensioning Cables 22
23
13 11
9 7 5 3 1 2
C
4 6 8 10 12
3
22. Tension each cable to 100 lbs by rotating the turnbuckle-side wrench. Do NOT rotate PTC fitting when tensioning cables. Tension cables from the center outward, following the sequence shown. Repeat sequence as necessary until all cables are fully tensioned.
23 Locate the center of the span and slide cable brace to its center position. Ensure that cable brace is straight/vertical, and then tighten both top and bottom set screws using a 3/32” Allen wrench.
» NOTE: 42" rail height (with 13 cables) shown here.
10
Have Questions? 1–800–BUY–TREX
NOTE: Construction methods are always improving. Please ensure you have the most up-to-date installation instructions by visiting: trex.com
XSSTC-0725
Made with FlippingBook. PDF to flipbook with ease