TREX SIGNATURE® X-SERIES™ HORIZONTAL CABLE RAIL Installation Instructions
9c
11
11. Tighten screw in locking assembly using a 5/32" Allen wrench.
Note: If locking assembly does not stay in place, use a
flat head screwdriver or other tool to hold this down while tightening set screw.
Note: Cables removed from image above for clarity.
Fastening Pass-Through Post Bracket to
12
9c. For 6' spans (or spans that have 1 top rail), install rail onto both X-Series Anchor Posts. Installing Top Rail Straight Brackets in X-Series Anchor Posts
Pass-Through Post (When Required)
12. Install two barrel bolts through Pass-Through Post as shown. Insert screw on opposite side and tighten using a 1/8” Allen wrench.
10a
Dovetail
Threading Push-to-Connect Fittings into Turnbuckles
13
10a. Position the top rail straight bracket PARTIALLY into the X-Series Anchor Post as shown. Pull up on top rail to expose the dovetail on the top rail straight bracket.
10c
Locking Assembly
10b
10b. Slide the top rail locking assembly onto the dovetail on the top of the bracket. 10c. Slide the bracket down until it sits on the cable infill adapter. Note that the screw in the locking assembly may need to be loosened to allow the locking assembly to fit properly in the X-Series Anchor Post.
13. Thread each push-to-connect (PTC) fitting into the turnbuckle on each short cable until the threads just disappear in the turnbuckle. Ensure threads are flush with the end of the turnbuckle.
8
Have Questions? 1–800–BUY–TREX
NOTE: Construction methods are always improving. Please ensure you have the most up-to-date installation instructions by visiting: trex.com
XSHZC-0725
Made with FlippingBook. PDF to flipbook with ease