SLIDE ACTION COMPONENTS Slide Retainer Assemblies
NOTES: 1 Lubricate all metal-to-metal contact areas before first use and every 100,000 cycles (or more frequently as required). Use a good grade of moldmakers’ non-melting type grease rated for the operating temperature to be encountered. 2 Do not operate at temperatures exceeding 225°F. 3 If two or more retainers are used, mount them uniformly to provide a balanced operation. Retainer sizes should not be mixed in a multiple retainer application. 4 Surface to which retainer is mounted should not prevent retainer from pivoting freely. 5 Replace retainer assembly and/or dowel pin when total wear in jaw area or on dowel pin exceeds .010. 6 Replace compression spring every 1,000,000 cycles or as required, following procedures packaged with retainer.
C
P
B
B
Section B-B
T** REF ONLY
L C’BORE +.001 –.000
A
+.000 –.005
M
TAPPED HOLE MUST NOT BE COUNTERSUNK
K TAPPED HOLE
B
Retrofit Data for Molds with Previous Design Slide Retainers
K TAPPED HOLE AND TAP DEPTH BELOW C’BORE
M C’BORE DEPTH P
T** REF ONLY
FOR REPLACEMENT OF SLIDE RETAINER ITEM NUMBER
NOTES: A. Existing pocket and tapped hole for previous slide retainer (MRT22, 44 or 88). B. Drilling, tapping and counterboring for shoulder screw at new location is required per drawing and chart dimensions. provide support for retainer positioning guides in areas designated by dimension P or centering guide blocks must be added. C. Existing pocket must
ITEM NUMBER
L C’BORE
PSL0001 #10-24 X .50 DEEP .249 .310 .61 .620 PSL0002 1/4-20 X .56 DEEP .3115 .430 .88 .875 PSL0003 5/16-18 X .62 DEEP .374 .580 1.57 1.325
MRT22 MRT44 MRT88
**Dimension T is for reference only. See charts and application drawings to determine specific installation dimensions.
HOW TO ORDER: Use Item Numbers in charts for ordering.
23
U.S. 800-626-6653 ■ Canada 800-387-6600 ■ . Mexico 52.442.713.5666 ■ . dme.net ■ store.dme.net
Made with FlippingBook - professional solution for displaying marketing and sales documents online