Flywheel
Tools
Flywheel Pullers Used for the removal of the Flywheel or rotor if applicable. Premium quality high carbon steel and heat treated for strength and durability. For our full range of pullers, please see our Full Tools Catalogue.
00-104/102
00-101
00-097
00-126
00-236
00-231
00-407
00-863
00-864
00-376
00-085
Flywheel Extractors with thread on Outside of Extractor
Flywheel Extractors with thread on Inside of Extractor
Flywheel Extractors Stud Type
Size (mm) 26 x 1.50 & 27 x 1.25
Thread
Part No.
Size (mm) 24 x 1.50 26 x 1.00 28 x 1.00 28 x 1.00 33 x 1.50 35 x 1.50
Thread
Part No.
Size (mm) 20 x 1.50
Thread
Part No.
Right Hand 00-236 Right Hand 00-231 Right Hand 00-407 Right Hand 00-863 Right Hand 00-864 Right Hand 00-376
Right Hand 00-085
Right Hand 00-104/102
27 x 1.00 27 x 1.00 30 x 1.50
Left Hand 00-101 Right Hand 00-097 Right Hand 00-126
Univ. Rotor Puller 6 Sizes
Flywheel Puller / Primary Gear Extractor Designed to remove the rotar and primary gear on a KTM50 02-07. Comes with 4mm, 5mm and 6mm hardware. Replaces OEM tool 59029021044. Flywheel Puller 00-312
A specially designed tool for standard AC flywheel rings. Features 6 different sizes: M27x1.0L, M24x1.0R, M18x1.5R, M16x1.5R, M14x1.5R and M10x.125R. Part No. 00-088 Trade PK of 5 00-088.PK5
Clutch/Flywheel Holding Tool
Pilot Bearing Puller
Bridge type - Pilot bearing puller. A very slim line 3 jawed design internal puller for removal of most flywheel pilot bearings. Work travel: 13-38mm. Pilot Bearing Puller 00-437
Designed to hold clutch baskets, flywheels, gears, sprockets etc. Jaws open to 5” wide. Made of medium carbon steel with hardened jaws. A very usefull workshop tool for holding any kind of mechanical work. Clutch/Flywheel Tool 00-890 Trade Pack of 10 00-890.DR.PK/10
Cr Seal/Bearing Retainer Tool (Ktm) 22mm hex and 3/8 square drive. Precision design prevents damage to the retainer ring after peened “stakes” have been removed by drilling. Replaces the OEM Honda tool to remove and replace the rear wheel bearing/seal retainer ring, OEM REF: 41231-430-000. For use on: CR250R 1978-81. CR Seal/Bearing Retainer Tool 00-214
47Mm Cr Seal Bearing Retainer Tool
Versatile design features a 22mm hex and 3/8 square drive. Precision design prevents damage to the retainer ring after peeded “stakes” have been removed by drilling. 47mm repaces OEM tools 07HMA-KS70100 AND 07YMA-KZ40100 to remove and replace the rear wheel bearing/seal retainer rings. CR125/250 87-88, 00-02, CR500 87-88. 47mm Retainer Tool 00-213
*Please See Our Tools Catalogue For Full Range Of Products
E-mail: sales@oro2u.com
www.oro2u.com
A5
Made with FlippingBook - Online magazine maker