WORKPLACE SAFETY PROGRAM
5.5 EMERGENCY EVACUATION
If evacuation is needed, any manager/supervisor/area lead will page all areas (page key + * on an intercom phone) and announce three times: “Emergency! Evacuate the building immediately. Go to your designated area.” Alarms will also sound. Stop work and exit immediately by the nearest posted route, do not shut down machinery or collect personal items. Go directly to your designated assembly area. Do not leave company property, go to vehicles, smoke, or use cell phones during evacuation. Assembly areas: Machine Shop/Deburr/All Quality/Spray & Fuse: Front of building, southwest corner (grass side of main entrance drive). Foundry/Pattern Shop/Maintenance: Front of building, northwest corner (grass side of sand drive). Front Office/Visitors: Front of building, west side, between the two areas above. Accountability & roles: HR (all office areas, retrieves Visitor Sign-In) brings the SDS binder to the assembly area. If any designee is unavailable (e.g., 2nd/3rd shift), available supervisors coordinate coverage. Utilities (gas): Foundry Supervisor shuts the main gas valve (north outside wall; use the wrench above the fitting; turn clockwise to stop; leave the wrench in place while gas is off). If no Foundry Supervisor is present, Machine Shop Supervisor does this. After the all clear, Maintenance Manager and Foundry Supervisor close local gas lines; Maintenance reopens the main and confirms back; supervisors then authorize equipment restart per manufacturer instructions and monitor start-up. CNC restart check: Before production resumes, operators visually confirm no electrical shock hazards, no loose/broken tooling, and no broken/missing clamps. Re-entry: Only a Company Officer (CEO/President/CFO/COO) may give the all clear. No one re-enters before that. Evacuation drills occur at least annually. Keep aisles, exits, alarms, and extinguishers clear at all times. Designated personnel conduct sweeps and headcount: Maintenance Supervisor (2nd floor, lunch/bathrooms); Machine Shop Supervisor (all machine shop areas); Finishing Supervisor (Deburr/Assembly & Spray/Fuse); Foundry Supervisor (all foundry, maintenance, pattern shop); Quality Lead (Quality/NDT/Visual);
TAMPA BRASS AND ALUMINUM CORP | PAGE 24
Made with FlippingBook - Share PDF online