Before beginning your installation, consult with local authorities regarding the codes governing all such installations. DO NOT connect your Ignite Tech Furnace to any flue that is servicing ANY other appliances. The Ignite Tech Furnace may be placed outdoors or indoors. If outdoors, it must be placed on a level, non-combustible base, preferably a 4’ x 8’ concrete pad, as close to the building as clearances to combustibles permit – do not place the furnace more than 25 feet from the building . The furnace must be connected to a grounded electrical circuit with access to a backup generator (2000 watt minimum). If locating the furnace more than 10’ from the building , a minimum of 6’ of Class “A” HT 2100 All Fuel 6 inch Chimney Pipe is required. If installing indoors, your furnace must be placed on a non-combustible floor. Air for combustion must be provided into the room where the furnace is located. Allow air free access to furnace for combustion and ventilation. Maintain the following clearances: • Front = 48 inches • Rear = 31 inches • Sides = 12 inches • Heat Duct = 6 inches for the first 16 inches from the back of the furnace, and 3 inches beyond Maintain the “10/2 Rule” for the flue, which says the flue must be 2 feet higher than any part of the building or peak of the roof within a horizontal distance of 10 feet. The 2 foot height does not include the cap. See diagram below.
2 Foot Minimum
10 Feet
4’ x 8’ Level Concrete Pad
Class “A” HT 2100 All Fuel 6 inch Chimney Pipe is required for optimum performance and must maintain a 2 inch clearance from combustibles. The Ignite Tech Furnace will ship with an anchor plate installed . If the anchor plate provided with your furnace does not fit the chimne y your local dealer has in - stock, please call our toll free number for assistance : 1-800-875-4788 . IMPORTANT: Please keep in mind that different chimney manufacturers’ pipe will not interchange with other brands. A tube of high-temp silicone caulk is included with your furnace. Before using the silicone to install the anchor plate to the top of your Ignite Tech Furnace, ensure the chimney you purchased will f it the anchor plate. Guy wire brackets are attached to the sides of the Ignite Tech Furnace. A heavy gauge of stainless steel wire can be purchased from a local hardware store to use as guy wire to help support your chimney. Attach the appropriate chimney pipe lengths to the adapter plate finishing with a chimney cap. IMPORTANT: Your furnace requires its own chimney system and cannot share a flue with any other product. DO NOT USE GALVANIZED OR BLACK PIPE AS A FLUE FOR YOUR FURNACE.
4
Made with FlippingBook - professional solution for displaying marketing and sales documents online