BGB: Wind Brochure

CAGE & BUS-BAR ASSEMBLIES:

Preset Cage Assemblies Cage assemblies are mounted to the stator side of the application and are used to mount brush holders in the correct position relative to the slip ring. Brush holders can be pre- positioned to speed up assembly on the turbine. As brush positioning is critical relative to the slip ring surface, correct alignment of the brush is imperative. This allows for optimum surface contact from day of installation.

Bus-bar assemblies are used for the termination of brushes to generator main stator cables. These are normally incorporated as part of the cage assembly. Bus-bar Assemblies

* Full Technical specification available on BGB website: www.bgbinnovation.com

9

Made with FlippingBook - Online catalogs