BRAHM TM BC Central Collector Series
NOTE:
The dust trays and hoppers may be attached to the unit before the unit has been placed on the stand. The BC24 through BC108 models must be lifted into place before being bolted together. Do not try to lift these models fully assembled.
NOTE:
The Brahm™ Collector can easily be moved by using a fork lift truck. Place the forks under the unit. Be mindful not to damage the dust tray or hopper mounting angles on the bottom of the unit. Attach the lifting chains or cables to the forklift “headache” bar. Attach the other end of the lifting chains or cables to the lifting lugs. Keep in mind, the motor side of the unit is heavier and forks may need to be shifted toward this side. Make sure not to scratch or damage the unit. Place cardboard between the unit and the fork lift truck to prevent damage When possible, lift and set the unit from the back side to reduce risk of damage to the filter and dual compartment doors. When setting the unit, be mindful of the bottom of the unit. Make sure the unit feet are placed inside the stand corners to prevent damage to the stand. The feet of the unit should line up with the flanges on the corners. Lift both halves onto the stand. Once both halves are on the stand, they can be bolted together. Make sure to bolt the halves together before bolting the unit to the stand. If bolted to the stand first, the unit may leak where the two halves are joined together. Once the unit is on the stand (and halves are bolted together where applicable), the unit can be bolted to the stand. Attach the unit to the stand using 3/8"-16 x 1" bolts. These bolts should be placed through the flanges on the top of the stand and into the weld nuts on unit's feet. Make sure the bolts
are secured with washers and lock washers to prevent loosening over time. Secure the stand to the ground using customer supplied anchor bolts.
sales@clean-air.com
clean-air.com
1-866-665-1829
Made with FlippingBook Online newsletter maker