BRAHM TM BC Central Collector Series
2) Secondary Detection If the smoke sensor has tripped, but not a heat sensor, air flow should stop and heat should build up in the filter compartment. This will cause the secondary heat sensors to trip. Caution: In the case of filter misalignment, the smoke sensor will trip, but the heat sensor will not. This is due to smoke bypass. 3) Tube Heat Detection If fire is present in the filter compartment, the temperature will rise and melts the tubing, This will release the fire suppression agent. 4) Manual Detection If the unit is still operating, immediately locate the manual fire suppression system Fire Pull. Operate the switch by pulling the lever downward to engage the fire suppression system. The system will block the airflow, shut down the power to the motor controls and turbo controller, and fill the filter compartment with suppression agent after 20 seconds. 5) Alert For safety, immediately follow your plant specified Fire Plan. The system is NOT tied into the plant fire protection system by Clean Air Industries . Alert officials! 6) Extinguish The suppression agent will contain and possibly extinguish a fire. However, due to the volatility of materials trapped in the filters, they may reignite. It is recommended that Safety Personnel using personal protective equipment immediately shut down main power to the unit and remove the filters from the plant environment. Once the suppression agent generator has been activated, power can be turned off. NOTE: Opening the door will allow the fire suppressing agent to escape from the unit and allow additional oxygen to enter the system.
sales@clean-air.com
clean-air.com
1-866-665-1829
Made with FlippingBook Online newsletter maker