BRAHM TM BC Central Collector Series
Place a 3/8" lock washer followed by a 3/8" flat washer onto a 3/8"-16 x 1" hex head bolt. All hardware used here is zinc plated. Slide bolt into front right hole in corner of dust tray with the threaded shaft upward. Making sure the holes are aligned, begin to screw the bolt into the hole part way. Repeat this bolt installation with the bolt hole in the opposite corner. Make sure to leave the bolts loose to allow installation of the remaining bolts. Once all bolts have been loosely installed, use a ratchet or wrench to tighten bolts down and compress gasket. Work around dust tray body to make sure all bolts are properly tightened. If the unit is not mounted on a stand, the unit can be lowered back down once the dust tray body has been mounted. Slide the dust tray into the dust tray body. Place a 3/8" lock washer followed by a 3/8" flat washer onto a 3/8"-16 x 1" hex head bolt. All hardware used here is zinc plated. Repeat this with a second bolt set. Insert a screw and washer sets into the two bolt holes on the front face of the dust tray. Align the first hole in the dust tray with the weld nut in the dust tray body. Screw in the first bolt partway. Align the second hole in the dust tray with the weld nut in the dust tray body. Screw in the second bolt completely, making sure it is tight. Finish tightening down the first bolt completely.
sales@clean-air.com
clean-air.com
1-866-665-1829
Made with FlippingBook Online newsletter maker