O PTION M ODE : R UN P LS DEL P
“Run Pulse Limit” - This option sets the pressure differential at which the running pulse sequence will
be activated in Automatic Mode (see Auto Mode: Above). This pulsing state is referred to as the
online cleaning cycle. To change the value, press the ‘OK’ button. The number of pressure value will
begin to flash. Use the ‘+’ and ‘ - ’ buttons to increase and de crease the amount of cycles respectively.
Press the ‘OK’ button again to set the counter value.
O PTION M ODE : A LARM DEL P
“Alarm Limit” - This option sets the pressure differential at which the filter cleaning alarm will be
activated in Automatic Mode (see A uto Mode: Above). To change the value, press the ‘OK’ button.
The number of pressure value will begin to flash. Use the ‘+’ and ‘ - ’ buttons to increase and decrease
the amount of cycles respectively. Press the ‘OK’ button again to set the counter value.
O PTION D EFAULTS
The Streamer will arrive preprogrammed with no necessary adjustments needed. The Option Modes
allow for the changing of some variables, which may extend filter life or increase performance on non-
standard applications.
If the settings are changed, the defaults are as follows:
Option Mode: ShutDown Pls #:
05
Option Mode: Shutdwn delP:
3.0
Option Mode: Run Pls delP:
7.0
Option Mode: Alarm delP:
9.9
Copyright © Clean Air America, Inc.
Streamer User Manual, March 2015
Page 33 of 54
Made with FlippingBook - Online magazine maker