Trex Select T-Rail® Railing Install Instructions

TREX SELECT® COMPOSITE T-RAIL STAIR RAILING Installation Instructions

HOW TO INSTALL STAIR RAILING WITH GASKETS AND BRACKET COVERS/ CONTINUED

Measuring and Cutting Stair T-Rail

Attaching Brackets on Stair T-Rail NOTES: »

9

8

 For attachment of brackets to posts, use at least a 3" long drill bit or extension so as to not damage sides of rails when installing. » SET DRILL TO LOW SPEED AND LOW CLUTCH SETTING WHEN INSTALLING THESE SCREWS. DO NOT USE IMPACT DRIVER.

8. Place two balusters into lower stair rail at each end closest to the post. 9. Position T-Rail onto balusters, ensuring balusters are fully seated in rail (position to side of post), and ENSURE balusters are spaced evenly AND parallel with posts.

T-Rail Lower Post Stair Bracket

T-Rail Upper Post Stair Bracket

12a

12a. O n the T-Rail at UPPER POST location, position the T-Rail bracket so

10

that it overhangs the rail by the thickness of the gasket. Install two upper screws into underside

of T-Rail using #8-18 x 1" self-drilling screws (C3). Remove gasket, as this will be installed in future step. DO NOT INSTALL SIDE SCREWS AT THIS TIME.

10. M ark stair T-Rail at post intersections.

12b

12b. If using the T-Rail aluminum stiffener,

KEY Mark Cut

KEY

11a. R emove T-Rail and from marked measurement in previous step, substract 1/16" from each end of rail to allow for gaskets, and cut along the marks.

11a

slide this inside T-Rail as shown. Note that the stiffener must be slightly shorter to allow for brackets to be installed. Screws from brackets are NOT to penetrate the stiffener. LOWER POST location, position the T-Rail bracket so that it overhangs the rail by the thickness of the gasket. Install two upper screws into underside

1/16" (1.6 mm)

1-1/2 "

1/16" (1.6 mm)

12c

12c. On the T-Rail at the

Cutting T-Rail Aluminum Stiffener (if required) 11b. F or stair railing installations over 6' in length, the T-Rail aluminum rail stiffener must be used. The stiffener MUST be cut 1-1/2" shorter than the T-Rail.

11b

of T-Rail using #8-18 x 1" self-drilling screws (C3). Remove gasket, as this will be installed in future step. DO NOT INSTALL SIDE SCREWS AT THIS TIME.

3

1-1/2 "

4

Have Questions? 1–800–BUY–TREX

NOTE: Construction methods are always improving. Please ensure you have the most up-to-date installation instructions by visiting: trex.com

STRS-0726

Made with FlippingBook. PDF to flipbook with ease