TREX SIGNATURE ® HORIZONTAL LINE AND CORNER CROSSOVER BRACKETS Installation Instructions
HOW TO INSTALL HORIZONTAL LINE AND CORNER CROSSOVER BRACKETS TREX SIGNATURE®
PARTS
A. Line Crossover Bracket B. Corner Crossover Bracket C. Wedge Plate D. V-Wedge E. 5/16" x 2" SS Bolt F. 5/16" SS Nut (1/2" wrench size) G. Line Crossover End Cap
A
B
C
E F
G
D
IMPORTANT NOTE REGARDING CUTTING SIGNATURE POSTS: » S ignature posts must be cut to proper length when using crossover brackets: 36" rail height – cut post to 34" height (measured from deck surface) 42" rail height – cut post to 40" height (measured from deck surface)
Wedge Plate Assembly
2
1
1. Insert the bolt through the hole in wedge plate.
2. A lign and insert the wedge plate with bolt into the v-wedge. Slide the wedge plate in until the ends are flush with the ends of the v-wedge.
1
Have Questions? 1–800–BUY–TREX
NOTE: Construction methods are always improving. Please ensure you have the most up-to-date installation instructions by visiting: trex.com NOTE: Construction methods are always improving. Please ensure you have the most up-to-date installation instructions by visiting: trex.com
SCB-0321 SCB-0422
TREX SIGNATURE ® HORIZONTAL LINE AND CORNER CROSSOVER BRACKETS Installation Instructions HOW TO INSTALL HORIZONTAL LINE AND CORNER CROSSOVER BRACKETS/ CONTINUED TREX SIGNATURE®
Installing Wedge Plate Assembly Into Top of Post
4b
3
1/4" (.64 cm)
Bottom of threads
4b. Place the corner crossover bracket over the bolt onto the end of the post.
3. Insert assembly (from step 2) into the top of post. Stop when top of v-wedge is about 1/4" into top of post.
5
Note: Threads of bolt will be slightly above the end of the post.
1
4a
5. Thread the nut onto the bolt. When attaching crossover end cap, slide u-channel on end cap under the nut until cap is flush with the end of the bracket. End cap is for use with the line crossover bracket only (when terminating a rail at a line crossover post).
4a. Place the line crossover bracket over the bolt onto the end of the post.
6
6. Tighten the nut to
10 ft·lbs with a torque wrench with 1/2" socket adapter.
IMPORTANT NOTE: For Line Crossover Bracket: Align the bracket such that the rail channel is perpendicular (90°) to the length of the wedge plate assembly.
2
2 Have Questions?
NOTE: Construction methods are always improving. Please ensure you have the most up-to-date installation instructions by visiting: trex.com
1–800–BUY–TREX
SCB-0422
Page 1 Page 2Made with FlippingBook interactive PDF creator