To Splitter
To Splitter
GFCI Outlet
GFCI Outlet
EXAMPLE OF A 1 ROW LIGHT INSTALLATION FOR JOISTS LESS THAN 8'
9E
6 " (15.2 cm)
9B
Dimmer (Optional)
Timer
Dimmer (Optional)
Timer
SPLITTER
LIGHT
TREX Transformer
TREX Transformer
To Splitter
ROW 1
9F
Joist Length
Light connection
EXAMPLE OF A 2 ROW LIGHT INSTALLATION FOR JOISTS BETWEEN 9' AND 12' (2.76 - 3.65 M) Light connection
Connection wire
Dimmer (Optional)
Connection wire
9C
9’ - 12’
Connection wire
ansformer
Connection wire
9G
Light connection
Connection wire
ROW 1
ROW 2
EXAMPLE OF A 3 ROW LIGHT INSTALLATION FOR JOISTS BETWEEN 13' AND 16' (3.96 - 4.87 M)
9D
Connection wire 13’ - 16’
INSTALLING THE LIGHTS »Install ceiling of your choice. Make sure to remember where wire end is located. »Mark where the light is to be installed and use 4-5/8" or 120 mm hole saw to bore hole, (a jig saw can be used instead of a hole saw). »Reach up through the hole and pull out wire end and attach to light. » Fold orange springs up and push light into opening. The springs will fold down and hold light in place. »If using directional feature, spin light so it shines on desired area.
ROW 1
ROW 2
ROW 3
MAKING CONNECTIONS 1. Install splitters to inside of framing using hardware provided. Install a splitter at every junction where you will run a row of lights. (9E) 2. Run wire through joist and roll up 1' - 2' (0.30 m - 0.60 m) extra wire in area the light will be installed. Staple to the side of the joist (making sure not to staple through the wire). 3. Cap off all unused female connections on splitters using caps provided or weather resistant silicone. (9G)
14 12
Made with FlippingBook - professional solution for displaying marketing and sales documents online