Complete Arch Manual

Casework Installation

INTRODUCTION We are pleased that you have chosen Diversified Casework for your new equipment, and it is our aim to give you the best available products. However, only proper installation will assure your complete satisfaction. Therefore, we have prepared this guide to aid you in the installation of you equipment. These instructions are for the installation of wood laboratory furniture assemblies. Please note the instructions contained in this booklet are basic guide-lines and are not meant to cover every situation you may be faced with during the installation process. There will be project specific conditions, which will have to be addressed as they occur. In these instances, please feel free to contact us and we will provide assistance as necessary to allow you to complete your installation. If there are any questions concerning installation or shipping problems, please contact the Installation or Customer Service Department of your local dealer. Figure 1 shows an exploded view of a typical wood item of laboratory equipment. Figure 2 is the assembled view of the same wood item Study these views carefully to fully acquaint yourself with the general scheme of laboratory equipment construction and method of joining the units together to make up a complete item of laboratory equipment. TYPICAL WOOD WALL AND FUME HOOD ASSEMBLY

Completed wood wall and fume hood assembly shown as an exploded view above. (Figure 2) DAMAGES IN SHIPMENT IMPORTANT! PLEASE CHECK YOUR FURNITURE IMMEDIATELY UPON ARRIVAL! Your furniture was accepted by the carrier in good condition and we urge you to inspect each carton for obvious damage to the contents before accepting it. If damage is found, insist that the driver note the damages on the freight bill and sign it. If, after uncrating the furniture, you find concealed damage which was not apparent while the furniture was crated and the driver was on the premises, contact the delivering carrier and request that they send a representative to make an inspection and prepare a concealed damage report. The inspection must be made and a concealed damage report filed within five (5) days after equipment is delivered. If the furniture is stored for period of time and then damage is discovered, trucking companies will not make or honor inspection reports. NET F.O.B. FACTORY OR COLLECT SHIPMENTS - Customer is responsible for filing any claim for damage. NET F.O.B. DESTINATION OR DELIVERED, INSTALLED JOBS - Shipper is responsible for filing claim; however, proper documents must be forwarded to accomplish this. PLEASE NOTE: We cannot make “No Charge” replacement on Prepaid Shipment without proper damage documentation, i.e. Freight Bills, Concealed Damage Reports, Inspection Reports, etc. A. If the damage is such that it can be repaired on the job, we recommend that you have the damage repaired and file your claim with the delivering carrier.

Exploded view of a typical wood wall and fume hood assembly showing the various parts required to make a complete laboratory furniture assembly. (Figure 1) Installation instructions for fume hoods are not included in this installation booklet, since specific installation instructions are included with each hood type shipped.

DiversifiedCasework.com | info@DiversifiedCasework.com | 877.348.9663

Made with FlippingBook interactive PDF creator