Pools are set to run during occupancy from 6:00am to 11:55pm . Pool Heat must be enabled on the reservation for a heated pool. The pool system has two controls for guest use. One is for the pool LIGHT and other is for the SPA .
As the pool is fully automated these are the only controls necessary for guest use. These timers can be activated at any time during a guest stay.
TIMER INSIDE (next to living room sliding door) is for the pool LIGHT . It is highly recommended that the light be used at night while bathers are present to ensure safe swimming conditions. TIMER OUTSIDE (next to living room sliding door) is for the SPA. When engaged the pool will stop circulating and the system will circulate through the spa only. This allows the spa to increase in temperature above the pool temperature and limit the pool from overheating. Pool Heat must be enabled in the reservation for the pool to be heated and for Guest Safety all pools are limited to 88 degrees F. The pool will only heat during operating run times. When the pool is in normal operating condition the pool and spa will heat to equal temperatures. After pool heat has been enabled in the reservation it will take time to heat the pool (3-4 hours before a noticeable change). When the Spa Timer is engaged the Spa will heat and be limited to 100 degrees (15-20 minutes of preheat time before a noticeable change). Item of note: when the Spa timer is engaged the pool will not continue to heat as all energy is supplied to spa. Engaging the Spa timer before the pool is heated will slow the Pool Heat process. To enable Pool Heat please call Rental Services (407)845-9191 . Assistance with any of the pool functions please call Maintenance (407)238-7900.
Made with FlippingBook Annual report maker