This is an interactive catalogue showcasing all our printing solutions offered to you. Click the links and videos within the catalogue for more information.
Email: techsupport@jgelectronics.com
Tel: 011 789 6033
Web: www.jgelectronics.com How to Youtube Chanel Videos: (5) JG Electronics - YouTube _______________________________________________________________________________________
Instructions for: 3D Sublimation Trophy Clock
Step 1 . Insert the big wooden trophy piece into the hole of the footstand. You will notice that the hole in the footstand is more to the back, making the front area wider. This is so that the Sublimer can go on the front in the end (the hole is intended not to be in the middle).
Step 2. Now you can glue the trophy that is inserted into the stand, onto the second part of the stand, like this:
Step 3.
• Before pressing the 2Tone Sublimer, make sure you press it the correct way around. • Test the Sublimer on the trophy first, by inserting the mechanism at the back of the unprinted Sublimer, then puch the mechanism through the hole on the Trophy. • The Sublimer should now touch the base of the trophy and be in line with the top right- hand corner of the Trophy. • If it doesn’t touch the base and just hangs in the air, then you know it’s the wrong way around and then you should swing the sublimer around until it looks like this:
Step 4. Now you can remove the clock mechanism, and remember what side is the top. Press the picture onto the 2Tone sublimer by using the 3mm 2Tone Sublimer Instructions. Step 5: Glue the 2Tone sublimer with the glue mentioned in the glue sheet instructions under instructions on the online store with this product, and apply it perfectly on the wooden trophy. PLEASE NOTE, YOU CAN NOT USE ANY SUPER GLUE OR GLUE, ONLY THESE SPECIFIC ONES. OTHER GLUES, EATS THE PRINT FROM THE SUBLIMER AND IT WILL DAMAGE IT , or make use of Hot Glue Gun for a second option.
Step 6. Insert the little black circle piece over the Mechanism and then insert it into the clock at the back through the sublimer.
Step 7. Insert the mechanism screw and arms at the front and you are done.
Page 1 Page 2 Page 3Made with FlippingBook - professional solution for displaying marketing and sales documents online