Technical Information
Installation and Adjustment Method for Cast Iron Finishing Milling Cutter
1.Clean wiper cartridge (7), completely release adjusting screw(6). 2.Clean each insert pocket, cartridge pocket, clean inserts and cartridges. 3.Install roughing inserts(1), wiper cartridges(7) and use finger to push them to the locating surface and lock the screws. 4. Install wiper inserts (5).
5.Measure the axial run out of each roughing and wiper insert. 6.Adjusting wiper inserts height through adjusting screw(6). 7.Wiper inserts Max. run out should be higher than roughing inserts by 0.03-0.06mm.
3
4
6.Adjusting screw 7.Wiper insert cartridge 8.Locking screw for wiper cartridge 9.Cutter
1.Roughing inserts(ON..05..) 2.Locking wedge 3.Double-headed wedge Locking screws 4.Wiper insert clamping screw 5.Wiper insert (LN12/15)
1
5
2
6
7
8
9
480
Made with FlippingBook - Online Brochure Maker