Trex ® Color Match Composite Screw
Installation Instructions
IMPORTANT NOTES: » N ot recommended for use in salt environments.
» N ot for use with sleeper systems that are less than 2X nominal thick. » A lways follow deck board manufacturer’s installation guidelines.
General Installation Recommendations: • Always use two screws per joist or stair stringer. • At board ends on the deck's edge, install screws placed perpendicularly at the recommended distance, at minimum of 1" from the board end and edge, without splitting the board.
PARTS & TOOLS NEEDED
2 1/2"
HEXSTIX ® HS-20 Drive Bit
Trex Hideaway ® Color-Match Composite Screw
Installation Instructions:
3
1
• F or best results pre-drill through deck board only, using 1/8” drill bit. When installing close to the end of the board pre-drilling is required.
• S crews are designed to be installed flush with decking surface.
DO NOT countersink screws.
2
• F or best results use an 18V or higher cordless drill and the included HEXSTIX ® driver bit, install fasteners at a 90° angle (perpendicular to the board). Always drive screw in one smooth, continuous motion.
Note: Never use Torx ® ttap ® bits in a HexStix ® screw. ttap ® is a registered trademark of Ttapdrive AS. Torx® is a registered trademark of Acument Intellectual Properties, LLC
31
Made with FlippingBook interactive PDF creator