REVOLVERS Handguns Mike Dubber Complete SAA Fixture Set Photos courtesy Marianne Kelley
If you are engraving a Colt Single Action Army or any type of wheel gun (gun with a cylinder), then you will need fixtures for holding the barrel, frame, cylinder, loading gate, ejector rod housing, hammer, backstrap, trigger guard, and screws. I have found that GRS has the Mike Dubber Complete Fixture Set which includes all the holding fixtures for the above, including scribes for horizontal and vertical straight lines on the barrel and cylinder. At the time of this writing, this kit is available from GRS but stock is limited to that on hand.
Barrel & Cylinder Holder Sliding uprights adjust to hold either the barrel or cylinder.
Scribe Fixtures Two fixtures allow you to mark the length or circumference of your piece.
Backstrap Holding Plates
Screw Holder
28
ISSUE NO. 10
GRS.COM
Made with FlippingBook - Online catalogs