Klass Double Sided Desk Direction for Use
The function can detect whether the motors are collected normally.
CHANGE THE DISPLAY UNIT(cm/inch)
• Once the display shows “E-3” and “rES”, it reminds you check whether any motors fail connected with control unit. Please connect the main cable again, wait at least 5 seconds.
E-3 rES
• Collect all the plugs.
rES
• Follow manual reset procedure.
With this function, you can make the control unit to factory setting.
RESET TO FACTORY SETTING
• Keep pressing “M” until the display shows “FAC”.
• Press “M”, and the control unit to factory setting (including memory position, container - and shelf - stop position, etc).
CODE MEANING
Code
Information
Operating
rES
Manual resetting
Refer to the progress of manual reset
Remove the load on desktop till it less than 800N (175 LBS) for further operation
ovr
Overloading
E-2
Anti-Collision function
It can be used normally after removing the obstacle
Operated continuously without suitable rest
dut
Make the desk rest around 15min for further operation
9
olgoffice.com | myolg.online
Made with FlippingBook - Share PDF online