PREVENTIVE MAINTENANCE INSTRUCTIONS Mountz FG Torque Screwdrivers (FG ENANCE INSTRUCTIONS Mountz FG Torque Screwdrivers (FG-8i - 125i)
_____________________________________________________________________________________
2.10
Using a 2 mm hex key, install the lock screw into the back of the adjustment screw. Note: This step does not apply to the FG-8i model. Next, use a 5 mm hex key to install the end cap, securing it firmly in place.
Final Steps 1. Cycle the tool at least 20 times at approximately 50% of its maximum torque range to distribute grease throughout the internal components. If either the cam or the main spring was replaced, a full 1,000-cycle break-in is required to ensure proper performan 2. Perform the torque setting adjustment, and tighten the lock screw securely. 3. Apply new calibration or identification labels as needed. in is required to ensure proper performance.
Product Hand Tools
Model
Document Number 3WI-8.5-093 Revision Date
FG Preset Screwdriver
Author
Revision
James Bassett
1-A
4.3.2025
For reference only if printed
Page 10 / 11
Made with FlippingBook Annual report maker