PREVENTIVE MAINTENANCE INSTRUCTIONS Mountz FG Torque Screwdrivers (FG ENANCE INSTRUCTIONS Mountz FG Torque Screwdrivers (FG-8i - 125i)
_____________________________________________________________________________________
1.5
Remove the spring cartridge assembly from the handle and wipe any grease from its outer surfaces. Next, remove the three 7/32” ball bearings from the cartridge assembly, then fully unscrew and remove the adjustment screw, spring, upper perch, and ½” steel ball. 7/32” ball bearings from Clean all components by wiping off grease with a shop cloth or by using a mild solvent. After cleaning, blow the parts dry with compressed air and allow them to fully dry. Set all parts aside on a clean shop cloth to prevent contamination. Wipe the inside of the FG handle near the front cam end using a shop cloth. inside of the FG handle near the front Pay special attention to thoroughly remove any residual Loctite from the threads on both the handle and the top cap to ensure clean reassembly. Inspect the cam surface to ensure it is clean, smooth, and free of damage. If there are any blemishes, wear marks, or surface irregularities, the cam should be replaced. Make sure to also inspect the balls and spring. Signs of wear are more common in too higher age or usage cycles. Signs of wear are more common in tools with
1.6
1.7
2.0 Tool Maintenance and Reassembly
Product Hand Tools
Model
Document Number 3WI-8.5-093 Revision Date
FG Preset Screwdriver
Author
Revision
James Bassett
1-A
4.3.2025
For reference only if printed
Page 6 / 11
Made with FlippingBook Annual report maker