CAVITY AND CORE COMPONENTS Cashew Gate Inserts STANDARD CLOSED GATE MINIFLOW® GTM SERIES Designed for tunnel gating of small, thin-walled moldings. This gate insert has a closed gate diameter and is therefore suitable for the use of low article weight and for very thin-walled moldings. • The closed surface enables the creation of individual gate diameters • Usable for all thermoplastics including fillers up to 50% glass fiber.
Material: 1.4028-X20Cr13 Stainless Steel Hardness 50 +5HRC
Miniflow GTM (without gate) recommended procedure to insert the gate.
1. Create the gate in 3D CAD. Draw a circle on the end face with the diameter or radius of the gate. Above shows a radius (R0.8) in green.
3. Thoroughly round off the sharp edge between the bent tunnel and the gate, e.g. by hand using a dia- mond mounted point.
2. Extrude this sketch with max. possible angle of inclination, depending on gate size, or remove the material immediately by cutting the material incl. draft/taper angle.
Installation Example
Additional Information: Page 9 - Viscosity table Page 10 - Installation dimensions
256
U.S. 800-626-6653 ■ Canada 800-387-6600 ■ Mexico 52-442-713-5666 ■ dme.net ■ store.dme.net
Made with FlippingBook - professional solution for displaying marketing and sales documents online