Assembly Instructions:
This unit must be installed on a flat and solid surface. The weight of the bed when filled with water is approximately 900 lb. Make sure the base is in the desired position before filling the mattress. You will not be able to move the base after the mattress has been fitted.
When the wooden base is in the correct position, you can then begin to set up the cover/foam supports and mattress.
1. Place the white vinyl cover on top of the base.
2. Lift the Velcro flap and unzip the top on 3 sides.
3. Fit the 4 foam supports inside the cover. There are 2 long ones and 2 short ones. They interlock to form the well that the vinyl mattress and liner will sit. 4. Make sure that the cover with the foam walls is sitting square on the base and that the zipper is at the front so that it can be easily closed when the bed is filled (if the long zipper and Velcro edge is against a wall, it may be difficult to close when bed is full). 5. Place the heater pad inside the well (the alloy plate must be face up). It can be anywhere as long as it is fully covered by the liner and mattress. If, however, it is placed at one end, this would make it easy to replace the heater without draining the bed completely should the need arise. Also, it makes it easier to exit the cable and thermostat. 6. Feed the cable and control around the foam so that it will exit in a top corner when the zip is closed. The thermostat MUST BE fitted to the outside of the cover. (Place between cover and the wall. This will keep it firmly in place). 7. Switch on for a few minutes to make sure that the heater is working. Then turn it off until the bed is full of water.
8. The bed is ready for the safety liner and mattress.
9. Place the safety liner inside the foam frame. The safety liner is there to contain the water should there ever been a leak. It is a large sheet of vinyl that should be evenly spread over the foam well for the mattress to side within. 10. Leave the liner loose until the mattress is filled. It can be tucked in after the mattress is filled. 11. Place the vinyl mattress within the safety liner. It has been vacuumed sealed at the factory. 12. Unscrew the cap and remove the plug on the valve. It will suck air back into the mattress. 13. Pull the valve up. It will be easy when the mattress is warm more difficult when cold.
14. Make sure the mattress is spread across the whole well area.
All TFH Products are to be used under adult supervision at all times.
TFH061422
Made with FlippingBook - professional solution for displaying marketing and sales documents online