MOBILE BASES The Handling System is made up of: Main control panel with push button panel, located on the front of the mobile system.
Opto electronic limit switch, positioned on each mobile base to restrict movement.
Photoelectric protective sensors, along both of the long sides of the frame of each mobile base which immediately halt the system in case of obstacles detected in the access aisle.
Any additional control keypads on the rear of the mobile system.
The main control panel is the electrical switchboard which provides electrical power to the individual mobile bases and is located on the front of each base, both in cold room and normal temperature environments. It includes: Auxiliary control equipment for the base to which it is attached.
A digital inverter which manages and checks movement. It ensures the racking starts and stops gradually, to avoid any sudden, dangerous jerks caused by heavy loads.
A keypad to control movement, located on the front of each racking unit.
An emergency push button positioned on the front of the mobile racking and capable of immediately halting movement in case of emergency.
A flashing warning light to signal movement, located in a very visible position on the front of each mobile racking unit.
The racking system is moved by sliding the mobile bases, which are constructed according to the dimensions and weight of the load units. Each mobile base is fitted with a series of electrical components which are needed for the operation of the base itself, both individually and in sequential logic with the other mobile bases in the system.
Mobile Bases
Mobile Bases around the pillars
Made with FlippingBook flipbook maker