Do not over tighten. Too much or too little tension will damage the drive belts and bearings. Check the tension frequently to be sure the deflection is at the value determined. To replace worn belts, loosen bolts on motor mounting plate and remove tension screws so the old belts can be removed from the sheaves. Remove the tension bracket and the bolts from the upper bearing bracket. Rotate the bracket 90 deg and remove old belt. Put new belt on and reverse the disassembly order to re-assemble.
Replacement belts should be ordered and installed in complete matched sets or one banded belt. Include old belt number(s) when reordering.
6.5
AFTERFILTERS
The afterfilter bags on the Clean Air Industries Amtech ATC High Efficiency Cyclone Dust Collector are semi-permanent and will give you long, efficient service if you perform routine maintenance. After each day’s operation, shake the filter bag(s) vigorousl y to remove the clinging material. If the afterfilter bag has a zipper-closed button, always empty the bag after shaking. Care should be taken to prevent tearing or puncturing the filter fabric. When adequate air volume cannot be restored by shaking the bags, simply remove them and replace with new filters. Under normal operating conditions, afterfilter bags should be replaced every two years for best performance. Be sure to include the model and serial number of your cyclone dust collector when ordering replacement afterfilter bags.
Page 17
sales@clean-air.com
1-866-665-1829
www.clean-air.com
Made with FlippingBook Annual report maker