8
!!!!! CAUTION !!!!!
Never lift cyclone by the motor. Do not rest blower assembly on fan wheel. Use clevises (not hooks) on lifting sling. Use spreader bars on lifting sling.
HOPPER “THROW OUT BIN” AND SUPPORT STAND ASSEMBLY
(The hopper “throw out bin” is optional)
Place the Support Stand assembly of the Clean Air Industries Amtech ATC High Efficiency Cyclone Dust Collector in its desired location. Use shims under foot pads as needed to level unit. Once base is level, fasten down with properly sized anchor bolts.
!!!!! CAUTION !!!!!
In preparing to assemble the hopper to its mating support base, connect a lifting sling to at least four positions on the unit. Distribute the load evenly. Location must be clear of all obstructions such as utility lines or roof overhangs. Take care to use proper lifting equipment and procedures. Drift pins may be useful for locating hopper mating sections. With the hopper section still supported, use hardware to bolt the sections together. Once all hardware is in place, go back and fully tighten all hardware on mating pads and all bracing. Disconnect the crane. If your collector has a belt-driven blower wheel, DO NOT attempt to make any pulley changes. Each pulley is sized for proper operation prior to shipment. No changes should be made unless specifically directed by Clean Air Industries .
CONE ASSEMBLY
!!!!! CAUTION !!!!!
In preparing to assemble the cyclone to its stand or hopper, connect a lifting sling to at least four positions on the cyclone. Distribute the load evenly. Location must be clear of all obstructions such as utility lines or roof overhangs. Install the cone assembly by setting the cone on top of the base. No sealant is required at this joint for the 1 Drum and 2 Drum units. Sealant is required for hopper base units. The cones are symmetrical so there is no specific orientation to consider. Using hardware provided, fully secure cone to base.
Page 9
sales@clean-air.com
1-866-665-1829
www.clean-air.com
Made with FlippingBook Annual report maker