Installation
NOTE
To position using the pipe connector You washer comes with a pipe connector that is designed to join the upper drain hose and the lower drain hose. You can choose to use the connector to combine two drain hoses into a single outlet. 1. Insert the clamp ring on the end of the drain hose, one for each drain hose. 2. Insert the pipe connector into the drain hoses. Make sure the longer side (A) fits into the drain hose running from the lower washer. 3. Fix the position of the clamp rings near the end of each hose. • To remove the pipe connector, follow these steps above in the reverse order.
A
STEP 7 Final check and power on • Before using your washer, make sure to remove the dehumidifying agent (silica gel) from inside the upper washer. • Do not eat or swallow the dehumidifying agent (silica gel). • The protective cover may form moisture on its surface after the washer has checked for a leak to ensure normal operation. This is normal, and does not indicate a defective part. Open the cover for a moment to remove the moisture. • Plug the power cord into an AC 120 V / 60 Hz / 15 AMP approved electrical outlet protected by a fuse or circuit breaker. Then, press POWER to turn on the washer.
English 34
FlexWash_WV9900M_DC68-03768A-07_EN.indd 34
2019-05-23 PM 2:55:21
Made with FlippingBook - Online magazine maker