CCS
Manual chuck switching system (CCS-HSP) ■ Highest repeatability and change-over accuracy ■ Central actuation for locking and unlocking ■ Large through-hole ■ Optical control for the locking status The described design is for draw tubes with O.D. thread only! For draw tubes with I.D. thread please contact SMW-AUTOBLOK! Installation onto machines with open center draw tube !
CHUCK SWITCHING SYSTEM
Checking of spindle and draw tube (customer side): In order to check the existing draw tube dimensions, the cylinder must be in the complete forward end position (dead stop in the cylinder)! Screw the draw tube firmly into the cylinder and secure it against rotation.
!
Checking of the dimensions for usability: All surfaces have to be clean and free of burrs. Carry out several measurements at different and opposed positions.
If the draw tube dimensions are within the dimensions (see table below) the existing draw tube can be used. If the draw tube dimensions are not within the dimensions (see table below) a new draw tube has to be used!
Spindle with short taper mounting
Spindle with cylindrical mounting
A 1
A 1
C 1
C 1
G 1
G 1
Spindle with short taper mounting Check dimensions
Spindle with cylindrical mounting Check dimensions
CCS Z170-A06 19 / 44.5
CCS Z220-A08
CCS A06-A06 25 / 50.5
CCS A08-A08
CCS A11-A11
CCS Z300-A11
Z-A
A-A
min. / max. max. min. max. (Ø) min. (Ø) min. (depth)
min. / max. max. min. max. (Ø) min. (Ø) min. (depth)
A1 B1 C1 D1
19 / 47
22 / 63
A1 B1 C1 D1
25 / 53
28 / 69
M56 x 1.5 M77 x 1.5 M100 x 1.5
M56 x 1.5 M77 x 1.5 M100 x 1.5
18 50 70
20 70 90 10
22 92
18 50 70
20 70 90 10
22 92
F1
- -
F1
115
G1
8
G1
8
10
12
SMW-AUTOBLOK 471
Made with FlippingBook Publishing Software