1941-48 Engine & Trans Mount Kits
GENERAL INFORMATION
Fits small block Ford V8 into 1941-48 Ford Car
This swap has two problem areas. No. 1: Oil pan/cross-member interference. A Bronco oil pan can be used or instructions are included for modifying your stock oil pan. No. 2: Lack of clearance around the steering and exhaust. It is hard to use power steering boxes without fender well headers. Stock steering just clears. The oil filter is acceptable if a short filter is used. No firewall modification needed. Some clearance must be done inside the X-center to allow room for the transmission. 1941-48 Ford Car TRANS MOUNTING KITS FOR SB FORD V8 Mounting kits are bolt-on style. Welding is required on models using a split wishbone. Before ordering, determine which frame type you have. Type I Cross-member center is riveted to the X-rails. Type II Cross-member is a welded unit. We are referring to the box where the X-rails meet. Note: Larger automatics require extra clearance in center of X. Use C-4 if possible.
CP-2202
1941-48 with Small Block Ford BOLT-ON ENGINE MOUNTING KITS
Installation is easy. Includes bolt-on frame adapters (can be welded on), engine side mounts, through-bolt cushion set, bolts and instructions. CP-2202 For solid axle $120.00 kit CP-2212G For I.F.S. $135.00 kit
TYPE I
TYPE I MOUNTING KITS (Cross-member center is riveted to cross-rails.) All transmissions. No provision for wishbone. Use with I.F.S. Rubber mount included. ES-2277 $110.00 kit All transmissions. Wishbone splitting kit added. Use with solid axle. Rubber mount included. ES-2276 $155.00 kit
1941-48 Car with Small Block Ford WELD-ON ENGINE MOUNTING KIT FOR MUSTANG II I.F.S. Easy to install. Includes engine side mounts, through cushion set, bolts and instructions. CP-2202G $100.00 kit
1941-48 WISHBONE MOUNTING KIT
TYPE II
This bolt-on wishbone mounting kit can be added to provide clearance for C-4 and manual shift transmissions. These transmissions do not need extra clearance to the side, but do need a drop for clearance below. This kit provides the needed clearance without splitting the wishbone. Use only with C-4 and stick transmissions. Can also be welded. AS-2083 $65.00 kit
TYPE II MOUNTING KITS (Cross-member center is a welded unit) All transmissions. No provision for wishbone. Use with I.F.S. Rubber mount included. ES-2272 $110.00 kit All transmissions. Wishbone splitting kit added. Use with solid axle. Rubber mount included. ES-2274 $155.00 kit
368
Made with FlippingBook - Online magazine maker