M60 Master – Crown Paints Master M60 Specification – M60 Master
471 Preprimed wood 1. Areas of defective primer: Take back to bare wood and reprime. 481 Uncoated wood 1. General: Provide smooth, even finish with arrises and moulding edges lightly rounded or eased. 2. Heads of fasteners: Countersink sufficient to hold stoppers/fillers. 3. Resinous areas and knots: Apply two coats of knotting. 481A Uncoated wood 1. General: Provide smooth, even finish with arrises and moulding edges lightly rounded or eased. 2. Heads of fasteners: Countersink sufficient to hold stoppers/fillers. 3. Resinous areas and knots: Burn resin out with a hot air gun and cloth.- care must be taken. Do NOT use a knotting solution. 481B Uncoated wood floors 1. General: Provide smooth, even surface by sanding. Vacuum clean to remove ALL residues 2. If the floor requires a colour apply ONE coat Sadolin Classic and allow to dry for 3-5 days 481C Existing coated wood floors 1. NOTE: Sadolin PV67 Heavy Duty Varnish can NOT be applied over conventional varnishes or stains. Remove all coatings, other than low build penetrating base stains. Coating removal should only be carried out by either chemical means, or by sanding: . 2. General: Provide smooth, even surface by sanding. Vacuum clean to remove ALL residues 3. If the floor requires a colour apply ONE coat Sadolin Classic and allow to dry for 3-5 days 481D Uncoated wood floors 1. General: Provide smooth, even surface by sanding. Vacuum clean to remove ALL residues 481E Existing coated timber 1. NOTE: Sadolin PV67 Heavy Duty Varnish can NOT be applied over conventional varnishes or stains. Remove all coatings, other than low build penetrating base stains. Coating removal should only be carried out by either chemical means, or by sanding: . 2. General: Provide smooth, even surface by sanding. Remove ALL residues 3. If the timber requires a colour apply ONE coat Sadolin Classic and allow to dry for 3-5 days 481F New wood 1. NOTE: Sadolin PV67 Heavy Duty Varnish can NOT be applied over conventional varnishes or stains. Remove all such coatings, other than low build penetrating base stains. Coating removal should only be carried out by either chemical means, or by sanding: . 2. General: Provide smooth, even surface by sanding. Vacuum clean to remove ALL residues 3. If timber requires a colour apply ONE coat Sadolin Classic and allow to dry for 3-5 days
99
Made with FlippingBook - Online magazine maker