VistaPure AutoFill Installation
A 12-foot length of clear polyurethane tubing is already attached to the AutoFill manifold. If the desired distance between the connection to the VistaPure and the autoclave is greater than 12 feet, simply order a longer length of the clear polyurethane tubing, as the distance from the VistaPure to the autoclave is not limited, except by the feed tubing.
Installing AutoFill on a STAT IM The VistaPure AutoFill for STAT IM device (S3020) can be installed on any new or older model 2000 or 5000 STAT IM autoclave as follows:
Manual Autoclave Wand
AutoFill Manifold & Float
Shut-O Valve
Flow Control
Tee
VistaPure
STAT IM
Installing AutoFill on a BRAVO The VistaPure AutoFill for BRAVO device (S3030) can be installed on any model BRAVO autoclave. In order to connect the VistaPure AutoFill to the BRAVO, one of the two tanks that come with the BRAVO must be selected as a “relay tank” since the BRAVO system uses a suction-lift pump to fill its reservoir when in its automatic-filling mode. Note that the relay tank must be located within 6 feet of the BRAVO unit, due to the suction-lift capacity of the BRAVO pump.
If using the small BRAVO tank:
Manual Autoclave Wand
Silicone Tubing to BRAVO
AutoFill Manifold & Float
Shut-O Valve
Flow Control
Suction Fitting
Tee
VistaPure
If using the large BRAVO tank:
AutoFill Manifold & Float
Manual Autoclave Wand
Shut-O Valve
Flow Control
NOTE: If using the large BRAVO relay tank, you must install the included extension rod
Tee
between the manifold and the float assembly.
VistaPure
Silicone Tubing to BRAVO
SciCan Inc. 701 Technology Drive Canonsburg, PA 15317 USA Distributed by:
Vista Research Group PO Box 321 Ashland, Ohio 44805-0321 USA Manufactured by:
Phone (419) 285-3927 VistaResearchGroup.com
Toll Free (800) 572-1211 Phone (724) 820-1600 Fax (724) 820-1479 uscustomerservice@scicanusa.com
scican.com scicanusa.com
SciCan @SciCan SciCanTV
Made with FlippingBook - Online Brochure Maker