Do not store flammable liquids adjacent to or inside spray booth. Read all product labels and instructions. Do not use any electric powered airless spray rigs, pressure washers or similar equipment when applying a low flash point solvent or peel coating. Run spray booth exhaust fan to purge dangerous vapors that could ignite or explode while cleaning or performing maintenance inside spray booth. AN APPROVED FIRE PROTECTION SYSTEM MUST BE INSTALLED ON YOUR SPRAY BOOTH TO COMPLY WITH NFPA 33, SECTION 9. PORTABLE F IR E EXTINGUISHERS MUST BE LOCATED IN OR AROUND YOUR PAINT MIX ROOM PER NFPA 10.
DANGER
2.2 Safety Decals
Severe Injury Hazard Do not enter equipment while in operation. Equipment may start automatically. Do not operate with door open. Installation, operation and service must be done by a trained technician only. Failure to follow these instructions can result in death or injury.
Printed in the USA
DANGER
Risque de Blessures Graves Ne pas entrer dans cet appareil pendant l’opération. Cet apparell peut démarrer automatiquement à tout moment. Ne pas opérer l’apparell avec la porte ouverte. L’installation, l’opération et l’entretien doit être eectués par un installateur éprouvé. Le non-respect de ces instructions peut entraîner de la mort ou des blessures.
DANGER
Printed in the USA
WARNING
Electrical Shock Hazard Disconnect electric before service. More than one disconnect switch may be required to disconnect electric from equipment. Equipment must be properly grounded. Failure to follow these instructions can result in death or electrical shock.
To protect you and others against death or serious injury, all applicable labels shown must be on the booth and must be legible. If any of these labels are missing or cannot be read, contact your RTT for replacement labels. WARNING This heater must be installed in accordance with the manufacturer’s instructions and local codes. In the absence of local codes, follow the National Fuel Gas Code, ANSI Z223.1 / NFPA 54 of the CAN/CSAB149 installation code. Cet aérotherme doit être installé en accord avec les instructions du fabricant et les régulations locaux. S’il n’y a pas des régulations locaux, l’installation doit être en accord avec le Code National de Gaz de Carburant, ANSI Z223.1 / NFPA 54 ou le Code d’installation, CAN/ CSA-B149. Improper installation, adjustment, alleration, service or maintenance can result in death, injury or property damage. Read the Installation, Operation and Service Manual thoroughly before installing or servicing this equipment. Installation, modification, reglage ou maintenance incorrectes peuvent provoquer de la mort, des blessures ou des dégâts matériels. Liser attentivement le manuel d’installation, d’operations et d’entretien avant l’installation ou l’entretien de cet équipment. P/N 01010431 Rev A
Printed in the USA
DANGER
Risque de Choc Electrique Débrancher le courant avant l’entretien. Plus qu’un interrupteur de verrouillage peut être requis pour débrancher le courant électrique de cet appareil. L’appareil doit être connecté à une source de courant reliée à la terre. Le non-respect de ces instructions peut entraîner de la mort ou des chocs électriques.
Imprimé aux É.-U.
8
Made with FlippingBook - professional solution for displaying marketing and sales documents online