5.2 Powering the System On and Off
HVR systems have one On/Off switch located on the I/O panel. In addition, the system PC includes an on/off switch located on the top of the unit. Turn the system off when not in use.
Before removing power, first close all computer files and applications, and then shut down the computer using the Windows “Shut down” button. Otherwise computer files could be corrupted by the sudden loss of power.
To power on the system, first apply power to the system PC and then to the metrology unit.
To power on the system PC, perform the following steps:
1. Ensure the system is properly cabled. Refer to the installation instructions in Section 4 of this manual. 2. Press the Power button on the top of the system PC. See the figure above. 3. Wait for the system PC to boot up completely.
To power on the metrology unit, perform the following steps:
1. Locate the On/Off rocker switch on the I/O panel. See the “Metrology Unit I/O Control Panel” figure above. 2. Press the rocker switch to the position marked “l.” “l” is the On position.
The system is now operational.
5.3 Switching the System from the Vertical to Horizontal Position
The HVR100 system weighs 106 pounds. Switching the system from the vertical position requires two people. Do not attempt to move the system without proper assistance.
To switch the system from vertical to horizontal position, perform the followi ng steps:
1. Ensure you have adequate space on the benchtop surface. The horizontal width of the system is 101.6 cm (40.0 inches). 2. Ensure the rear of the unit is free of all cabling. 3. Power Off the system by pressing the On/Off rocker switch to the “O” Off position. 4. With a person on each side of the system rotate the system backward using the rear pivots as a guide. You can also attach the lifting handles located near the I/O panel to help guide the system. See the figure below. 5. Ensure the system is resting on the level pads on the back of the unit. 6. Rotate the stage so that it is parallel to the ground. 7. Power On the system by pressing the On/Off rocker switch to the “l” On position.
28
Made with FlippingBook - professional solution for displaying marketing and sales documents online