I/O Control Panel
•
Carrying handle
•
System with Carrying Handle Attached
5.4 Switching the System from the Horizontal to Vertical Position
The HVR100 system weighs 106 pounds. Switching the system from the horizontal position requires two people. Do not attempt to move the system without proper assistance.
To switch the system from the horizontal to vertical position, perform the following steps:
1. Ensure you have adequate space on the benchtop surface. The system is 42.16 cm (16.6 inches) wide and 43.43 cm (17.1 inches) deep. 2. Ensure the rear of the unit is free of all cabling. 3. Power Off the system by pressing the On/Off rocker switch to the “O” Off position. 4. With a person on each side of the system pull the system upward using the rear pivots as a guide. 5. Ensure the system is level with the benchtop surface. 6. Rotate the stage so that it is parallel to the ground. 7. Power On the system by pressing the On/Off rocker switch to the “l” On position.
5.5 Access to Electronics
The back of the system is hinged and holds a compartment with all electronics other than the system PC. Removing the knurled hand-screw provides access to this compartment. This is for service access only. There are no user adjustments or controls behind the hinged back.
29
Made with FlippingBook - professional solution for displaying marketing and sales documents online