AVR Manual

AVR200 and AVR300 User Guide

5.5 Setting Up the System

To set up the system, refer to the following figures and perform the following steps:

1. Locate the I/O panel on the rear of the AVR system. The rear panel includes a sticker so that cabling locations can be easily identified. Refer to the following figure.

2. Connect the power cable to the connector marked “24V” on the I/O panel. This cable provides input from the power supply.

3. Connect the remaining end of the power cable to an appropriate power outlet.

4. Connect the DB9 connector for the joystick and emergency stop switch to the connector marked “Joystick” on the I/O panel.

Figure 23. AVR Rear I/O Panel Cabling

5. Connect the USB cable to the USB connector marked “M3” on the I/O panel of the AVR metrology unit to the USB connector on the rear panel of the system PC. This cable supports the encoder signals for the M3 software. Refer to the following figure. 6. Connect an additional USB cable to the USB connector marked “Camera” on the I/O panel on the AVR system to the USB connector on the rear panel of the system PC. This cable supports the camera signal.

Figure 24. System PC Rear Panel

35

6106 Revision D

Made with FlippingBook - professional solution for displaying marketing and sales documents online