6. Operating the System
This section provides information on the following operations for the HDV systems:
Powering on the system
•
Powering off the system
•
Adjusting and using the keyboard
•
Using the system controls
•
Verifying basic M3 software operations
•
Changing the lens
•
Replacing the fuse
•
6.1 Powering On the System
Background
HDV systems are shipped by Starrett fully assembled, electrically interconnected, and ready to run following the removal of retainers and packing materials. The systems are factory set for 115V or 230V AC power, depending on the destination country. Contact Starrett if you ever need to move a system to a country with different AC power. HDV systems have an On/Off rotary selector switch on the right side of the housing, and a rocker switch in the back just above the 115/230V power connector. Refer to the following figures. During normal operation, the toggle switch at the back should always be in the On position, and the rotary switch should be used to apply and remove power.
WARNING
Make sure that the power plug to which the system is connected is a properly rated and grounded receptacle. Do not energize the power cable until the entire system has been properly set up using these instructions.
Made with FlippingBook - professional solution for displaying marketing and sales documents online