HE400 Operators Manual
7
Y-Axis Handwheel
Raises and lowers the workstage.
8
Focus Handwheel
Moves the workstage in and out for focusing.
9
X-Axis Handwheel
For fine adjustment of the workstage along the X-axis.
10
Surface Illumination Light Guides
Provide surface illumination for measuring surface features of flat components. For the optimum illumination, release the clamp screws and pull out the guides. Position the guides as close to the component as possible to obtain optimum illumination, and tighten the clamp screws.
For components with a directional surface finish (such as ground faces), the surface texture should be vertical to give the brightest image on the screen.
The guides provide a ‘cold light’ source; minimal heat is radiated to the component.
5.2
Taking Measurements
1. Secure the component to the workstage with a suitableworkholder.
2.
Turn on the POWER switch.
3. Turn on the PROFILE light switch, and turn the focus control to produce a sharp image on the screen.
4. Refer to the Mx200 manual (M1 or M2 manual or QC manual) for setting up the Mx200 readout or M1 or M2 or DRO (and edge detector if fitted) and taking measurements.
Refer to 5.3 - Using the Digital Protractor for using the protractor.
Use the manual controls as required:
Linear measurements
: X- and Y-axis handwheels.
Angular measurement
: Angular adjustment control and digital protractor.
Surface features
: Surface illumination and light guides.
14
1000 0193 Rev C
Made with FlippingBook - professional solution for displaying marketing and sales documents online