AVX System User Guide
5.4 Setting Up the System
To set up the system, refer to the following figure and perform the following steps:
1. Locate the I/O panel on the rear of the system. Refer to the following figure. Cable locations are labeled for easy identification. 2. Connect the HDMI cable for the monitor to the location marked “HDMI” on the I/O panel. Ensure the remaining end is connected to the monitor. 3. Connect the monitor power cable to the location marked “Monitor” on the I/O panel. Ensure the remaining end is connected to the monitor. 4. Connect the joystick cable with DB9 connector to the locat ion marked “Joystick” on the I/O panel. 5. Connect the power cable to the location marked “1 Phase 100-240 VAC.” Connect the remaining end to an appropriate power source. Refer to “Electrical Specifications” in Section 4 of this document for detailed information. 6. Connect the dongle for the wireless keyboard and mouse to the location marked “USB” on the I/O panel.
Figure 25. Rear I/O Panel Cable Locations
7. If applicable, connect your network ethernet cable to the position marked “Network.”
8. Proceed to Section 6 for specific instructions on powering up the system.
35
1000 0074 Revision A
Made with FlippingBook - professional solution for displaying marketing and sales documents online