Portable Weld Fume Extractor
5) Remove the filter in the bag and tie the end of the bag closed.
6) Some excess dust and debris may need to be removed while the filter has been removed
from the unit. This can be done by sweeping the dust into the dust tray. The dust tray can
then be serviced as normal. Alternatively, excess dust in the filter compartment can also be
removed through the suction of a proper vacuum system.
7) Place the new filter onto the filter ring with the gasket seal end towards you. Make sure the
filter is properly seated.
8) Close and secure the end panel.
9) Turn the rotary switch to start the motor. Some dust or debris may have fallen into the filter
ducts; this dust would then be blown out when the unit begins to run.
Page 20 of 23
sales@clean-air.com
clean-air.com
1-866-665-1829
Made with FlippingBook interactive PDF creator