CLUTCH TOOLS
CLUTCH AND CRANK
FLYWHEEL & PRIMARY GEAR EXTRACTOR
Flywheel puller / Primary Gear Extractor. Designed to remove the rotar and primary gear on a KTM 50 2002-2007. Comes with 4, 5 and 6mm hardware. Replaces OEM tool 59029021044.
FLYWHEEL & PRIMARY GEAR EXTRACTOR
00-312.DR
00-312.DR
FLYWHEEL PULLER SET
Puller kit for pulling magneto flywheel or starter gear on Kawasaki Jet Ski 300/440/550. Will also fit the Yamaha WR 250F 2001-02, WR 400F flywheel and also some older Kawasaki 3 bolt flywheels. Kit includes; three 6x25mm and three 8x40mm bolts, 8mm bolt hole centre is 27mm to dead centre, 6mm bolt hole centre is 49.15mm to dead centre.
FLYWHEEL PULLER SET
00-047.DR
00-047.DR
CLUTCH & FLYWHEEL HOLDING TOOL
Designed to hold clutch baskets, flywheels, gears, sprockets etc. Jaws open to 5” wide. Made of medium carbon steel with hardened jaws. A very useful workshop tool for holding any kind of mechanical work.
CLUTCH & FLYWHEEL HOLDING TOOL
00-890.DR
00-890.DR
CLUTCH & FLYWHEEL HOLDING TOOL (TRADE PACK OF 10)
00-890.DR.PK10
CRANKSHAFT INSTALLATION KIT
00-409.FIR
These are specifically designed to install the crankshaft into most single cylinder motorcycles. Sizes included Male 1.0RH x M7, Male 1.25RH x M10, Female 1.0RH x M22, 1.0RH x M18, Female 1.5RH x M14, Female 1.0RH x M14, Female1.0RH x M16, Female 1.25RH x M12, Female 1.0RH x M12, Female 1.25LH x M12, Female 1.25RH x M10.
CRANKSHAFT INSTALLATION KIT
00-409.FIR
CRANKCASE SPLITTER
FIR Crankcase Splitter Tool. Will work on most two and four stroke engines with vertically split cases. Movable fingers allow a multitude of bolt patterns to be used. Includes 6mm and 8mm mounting bolts.
700-463.FI
CRANKCASE SPLITTER
00-463.FI
318
Made with FlippingBook - professional solution for displaying marketing and sales documents online