Preparation
Type of Ports:
F1023B
Outlet Ports
CxC Connection
Ensuring that all plastic and rubber parts are removed from the valve body (including the cartridge and integral stops), solder 1/2" copper tube to the valve inlet and outlet ports. Avoid soldering excessively at high temperature.
Hot Inlet Port
Cold Inlet Port
IPS Connection
F1023B-PEX
F1023B-PEX-90
F1023B-PEX-W-90 Alternate: F1023B-PEX-W-90-UP
F1023B-PEX-W
Alternate: F1023B-PEX-90-UP
r
F1807 compliant copper crimp rings
compliant cold expansion retaining rings
Diagram A shows typical measurements for reference only and Important: bottom port of valve to the tub spout outlet MUST be ½ ” DO NOT IMPORTANT: This pressure balancing valve must be installed with the cold inlet port (marked in blue color ) on the right side, (when facing the valve) and hot inlet port (marked in red color ) on the left. Ensure that all arrows and the word UP on the mud guard and valve body point upwards and the fluid logo is right side up.
Bath and Shower
H
C
WARNING: In keeping with standard plumbing practices it is essential that all tub/shower systems be tested extensively for leaks before
Bath Tub
must be copper, do not use PEX
plate should completely cover the rough-in opening when
pg 2
Made with FlippingBook Annual report maker