10.6 Additional SeaStar steering station or autopilot kit
1. Refer to illustration figure 10-17. 2. Determine the location of the second station or autopilot power pack. 3. Measure along the path of the tube routing from the upper helm pump to the second station or autopilot power pack. Multiply this length by three for the amount of tubing required. 4. Select the tubing kit based on the total system tubing requirement. WARNING! Do not cut SeaStar steering hose.
COMPENSATING LINE
UPPER HELM STATION
1
2ND HELM STATION OR AUTOPILOT
2
AUTOPILOT DETAIL
TO AUTOPILOT
1
1
Figure 10-17.
ITEM # PART # DESCRIPTION
QTY. REQ.
SEC. REF.
1 2
HT5_ _ _ HF6010
3/8” Dia. nylon or copper tube Fitting kit *
As measured 1
Section 10-5
Table 10-8. * For NPT helms use HF5502.
NOTICE! a) A compensating line is required between helm stations or the helm and autopilot power pack. b) All hoses should be routed with a gradual rise (particularly the com- pensating line) so that air will not be trapped in the lower helm station. c) The second helm station or autopilot power pack may be connected at any location between the upper helm station and the cylinder. For existing single station installations the nylon or copper tubing may be cut and the tee fittings installed at any convenient location.
10-14
EN
Made with FlippingBook - Online Brochure Maker