Tab Position Indicator LEDs
Shows the position of port and starboard tabs. At full retraction a single LED is shown at the top. As the tabs are extended the LEDs will illuminate to show the tab position. Lowers both tabs simultaneously, causing the bow to drop. Press and release to move both tabs a preset increment, or press and hold until the desired pitch is achieved. To enable fine control, the actuator speed is reduced for the first second the button is held, after which the actuators move at full speed for larger adjustments. Raises both tabs simultaneously, causing the bow to rise. Press and release to move both tabs a preset increment, or press and hold until the desired pitch is achieved. To enable fine control, the actuator speed is reduced for the first second the button is held, after which the actuators move at full speed for larger adjustments. Rolls the boat in the direction of rotation. Rotating the dial to starboard (clockwise) will cause the port tab to lower and the starboard tab to raise, causing the boat to roll to starboard. Turning the dial to port (counterclockwise) will have the opposite effect. Use this control with caution: turn one click at a time and wait a moment to see how the boat reacts before making further adjustments. While this control can be used to correct a list due to uneven loading, best practice is to load your boat as evenly as possible, and to keep passenger movement at a minimum while underway at high speeds. The relative positions of the tabs are maintained when using the Bow Down and Bow Up controls, so if you’ve used the roll control to correct for a list it will remain corrected as you alter the bow position. Press once to retract actuators to their fully retracted home position. Use this button when: • you encounter difficult sea conditions and need to raise the bow, • preparing to load the boat onto a trailer, • preparing the boat for lifting. The home button will immediately override any automatic operation of the trim tab actuators and return them to home position. When the tabs reach the home position the trim tab position indicator LED will blink three times.
Bow Down
Bow Up
Control Dial
Home
The Favorite button has two functions: 1. Set and recall a Favorite trim tab position. 2. Toggle Holeshot mode on or off.
Favorite
You can switch between these functions by pressing and holding the Favorite and Bow Up buttons together for three seconds. The system status indicator will briefly flash magenta to show the Holeshot function is enabled, or green to show the Favorite function is enabled.
The controller provides manual adjustment of the LED brightness.
LED Brightness
13-12
EN
Made with FlippingBook - Online Brochure Maker