Preparing to trailer or lift the boat Press the Home button. ✓ The actuators will retract. When both tab position indicators show only
one LED the tabs are fully retracted. You are ready to trailer or lift the boat.
NOTICE! Material damage Trailering or lifting the boat with the trim tabs extended may cause irreparable damage to the tabs and actuators.
13.4.5
Advanced features and operation
Setting and recalling a favorite position With this function you can memorize a trim tab position and return to it at any time with a single press of a button. To set a favorite position: Press the Favorite button (see figure 14-10) for five seconds. ✓ The system status indicator will flash cyan three times to confirm the position has been saved. To recall a favorite position: Press the Favorite button. ✓ The tabs will adjust to the saved favorite position. CAUTION! Varying sea conditions If sea conditions have changed since you last set a favorite position, use caution when recalling it. Adaptive Cruising Favorite set-point As you operate your boat and adjust the trim settings the system stores the latest stable setting as an Adaptive Cruising Favorite set-point. A stable setting is one that is maintained for twenty seconds while Holeshot mode is activated and the engine RPM or speed over ground meets a preset minimum. The system status indicator will flash cyan when the system has memorized a favorite position. The Adaptive Cruising Favorite set-point is used by the Holeshot mode, and is only available in systems in which Holeshot mode is enabled by the builder/dealer. Holeshot mode NOTE: Holeshot mode prerequisites • Holeshot mode requires an engine gear signal and either an engine RPM or GPS speed-over-ground source. • If your boat is equipped with Optimus Electronic Power Steering (EPS), or has an NMEA2000 network with an engine gateway, you will likely have the engine gear and RPM signal, and you may have an SOG source.
13-13
EN
Made with FlippingBook - Online Brochure Maker