3. Is there enough room in the splashwell for full engine tilt? Find the dimensions (B & C) of your splashwell. Check them against the minimum splashwell dimensions for full engine tilt for your engine and cylinder. Motor well dimensions required for BayStar front mount outboard steering systems
A
Cylinder model No.
# of engines
A
B
C Min. engine
C
center distance
HC4645-3 / 47-3 / 48-3 / 58-3
1
21” (534 mm) 6” (153 mm) 5” (127 mm) N/A
B
2 Twin engine applications not available
NOTES:
a) Ensure there is no interference between the BayStar cylinder rod and the splashwell boot or engine controls and cables.
b) Dimensional restrictions also apply to external motor mount brackets. c) E nsure dimension ‘A’ maintained through full trim/tilt range.
d) Maximum transom thickness 3” (76 mm). e) Engines less than 70HP may require up to an additional 1” (25 mm) of splashwell clearance.
Figure 3-7.
3.1.3 BayStar steering kits
BayStar Steering kits come complete with everything needed for an install, (some engines require additional kits and/or cylinder plate change, see application chart on page 3-6) the cylinder does not require the engine manufacturer drag link for connection. For your convenience two lengths of 20’ cut to fit tubing are supplied with the HK4200A-3 and two lengths of 30’ cut to fit tubing are supplied with the HK4230A-3 kit. NOTICE! HC4645-3 compact cylinder is included in both BayStar steering kits. If your engine requires the use of a cylinder other than HC4645-3 or HC4658-3 (refer to application guide on page 3-6) then purchase of a replacement pivot plate (noted on page 3-6) will be required.
Figure 3-8.
3-4
EN
Made with FlippingBook - Online Brochure Maker