Look, doc: no hands!
VistaPure’s patented AutoFill accessories replenish SciCan STAT IM ® and BRAVO ™ autoclaves with distilled-quality water automatically— enabling truly hands-free convenience. VistaPure AutoFill accessory kits work with all VistaPure systems and can be installed easily on any STAT IM 2000/G4 or 5000/G4, or any BRAVO autoclave, in just a few minutes!
No more purchasing and storing distilled water
No more spills while filling autoclaves manually
No more cycle-fault errors caused by forgetting to fill reservoirs
No more staff time spent filling autoclaves = more time with patients
AutoFill for STAT IM (S3020)
AutoFill for BRAVO (S3030)
scican.com
scicancanada.com
SciCan @SciCan SciCanTV
VistaPure AutoFill Installation
A 12-foot length of clear polyurethane tubing is already attached to the AutoFill manifold. If the desired distance between the connection to the VistaPure and the autoclave is greater than 12 feet, simply order a longer length of the clear polyurethane tubing, as the distance from the VistaPure to the autoclave is not limited, except by the feed tubing.
Installing AutoFill on a STAT IM The VistaPure AutoFill for STAT IM device (S3020) can be installed on any new or older model 2000 or 5000 STAT IM autoclave as follows:
Manual Autoclave Wand
AutoFill Manifold & Float
Shut-O Valve
Flow Control
Tee
VistaPure
STAT IM
Installing AutoFill on a BRAVO The VistaPure AutoFill for BRAVO device (S3030) can be installed on any model BRAVO autoclave. In order to connect the VistaPure AutoFill to the BRAVO, one of the two tanks that come with the BRAVO must be selected as a “relay tank” since the BRAVO system uses a suction-lift pump to fill its reservoir when in its automatic-filling mode. Note that the relay tank must be located within 6 feet of the BRAVO unit, due to the suction-lift capacity of the BRAVO pump.
If using the small BRAVO tank:
Manual Autoclave Wand
Silicone Tubing to BRAVO
AutoFill Manifold & Float
Shut-O Valve
Flow Control
Suction Fitting
Tee
VistaPure
If using the large BRAVO tank:
AutoFill Manifold & Float
Manual Autoclave Wand
Shut-O Valve
Flow Control
NOTE: If using the large BRAVO relay tank, you must install the included extension rod
Tee
between the manifold and the float assembly.
VistaPure
Silicone Tubing to BRAVO
SciCan Ltd. 1440 Don Mills Rd Toronto, ON M3B 3P9 CANADA Distributed by:
Vista Research Group PO Box 321 Ashland, Ohio 44805-0321 USA Manufactured by:
Phone (419) 285-3927 VistaResearchGroup.com
Toll Free (800) 667-7733 Phone (416) 445-1600 Fax (416) 445-2727 customerservice@scican.com
scican.com
scicancanada.com
SciCan @SciCan SciCanTV
Page 1 Page 2Made with FlippingBook Digital Publishing Software