Maintenance
DAILY MAINTENANCE CHECK FOR OPTIMUM PERFORMANCE
BEFORE STARTING WORK NOTE: For all tyre pressure and tension specifications refer to 1. SPECIFICATIONS - Tyre Specification Table. • Follow tension specifications. • Before mounting wheel to machine, check all hub and rim contact surfaces are undamaged and free of paint, dirt and grease. • Check tension wheel nuts for torque specifica- tions. • Check all pivot pins are fastened and anchor bolts are correctly tensioned. • Lubricate wheel stubs with standard viscosity oil. • For field operation: re-tension after 1st, 5th, then every 50 hours of operation. • For road travel re-tension first 3 miles (5kms), 10 miles (15kms), and thereafter at 25 miles (40kms) intervals. • Check tyres are inflated according to pressure stated on tyre. • Check discs and disc bolt tension to specified torque 450Nm +/- 50Nm. • Check for damaged, worn and fatigued parts. Have machine repaired if necessary. • Ensure all appropriate safety decals are se- curely attached to machine. • Check hydraulic system is fully primed 3. HY- DRAULIC OPERATION & SAFETY - Priming Hydraulic System. • Check all safety mechanisms are in place and operating correctly. • Lubricate rear roller bearings 5. MAINTENANCE - Lubrication of Heavy Roller Bearings. • Ensure Instruction manual has been read, un- derstood and stored with machine. NOTE: Always reset adjustments for front disc gang lateral positioning according to instructions 4. FIELD OPERATION - Lateral Front Disc Gang Positioning.
Disc bolts - Check first 10hrs of operation
Figure : 5.2 Disc Bolts.
Disc arm locating bolts - Check first 10hrs of operation
Figure : 5.3 Disc Arm Bolts.
5.4
2362P Fleximulch
OPERATOR & SAFETY MANUAL
2362P Op Book.indb 4
22/08/2022 5:50:49 PM
Made with FlippingBook - Online Brochure Maker